I’ve determined that spinning could work for my part. Are there any design tips I should keep in mind?

Some design tips to keep in mind are:

  • Where possible, allow a center pilot hole to reduce cost.
  • Use beads, grooves or flanges to add strength and rigidity.
  • Large corner radii will add strength and is more cost effective.
  • Design changes reducing the inside diameter are relatively inexpensive, increasing the inside diameter requires new tooling.
  • The smaller the tolerance, the more expensive the part.
  • Flexibility in part design results in increased savings.
  • Use I.D. dimensions on drawings where possible, as the spin tool is made from I.D. dimensions

Comment

No Very




Captcha Image