I’ve determined that spinning could work for my part. Are there any design tips I should keep in mind?

Some design tips to keep in mind are:

• Where possible, allow a center pilot hole to reduce cost.
• Use beads, grooves or flanges to add strength and rigidity.
• Large corner radii will add strength and is more cost effective.
• Design changes reducing the inside diameter are relatively inexpensive, increasing the inside diameter requires new tooling.
• The smaller the tolerance, the more expensive the part.
• Flexibility in part design results in increased savings.
• Use I.D. dimensions on drawings where possible, as the spin tool is made from I.D. dimensions